1. Bluefield Configuration Issue
Searching...

Bluefield Configuration Issue

Home › Forums › FABRIC General Questions and Discussion › Bluefield Configuration Issue

Log In Register Lost Password
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 12, 2026 at 8:15 pm #10047
    Stephen Mayhew
    Participant

      Hello,

      I am trying to run the example code to use a bluefield dpu in JupyterHub. When I run the code to configure the bluefield I get an error. I have attached a screenshot of the code and error message. Let me know if more information is needed.

      Thank you

      September 13, 2026 at 1:13 pm #10049
      Mert Cevik
      Moderator

        We will look into the problem with bluefield.configure() if there is a fix needed.

        On the other hand, dpu_ubuntu_24 image includes the BF-bundle file in /opt/bf-bundle directory. You can install according to standard installation steps (found in DOCA Downloads page)

        Specifically for bluefield.config(), I believe it’s executing the following, so that you can issue manually.

        sudo ip addr add 192.168.100.1/24 dev tmfifo_net0
sudo ip link set tmfifo_net0 up
sudo bfb-install --bfb /opt/bf-bundle/<BFB-FILE> --rshim rshim0
        September 14, 2026 at 3:49 pm #10055
        Komal Thareja
        Moderator

          Hi Stephen,

          There was a mismatch in the code for configure function and the actual BFB image on the host. I pushed a fix for this and updated the notebook too. The notebook should work now.

          Thank you for sharing your observation and helping us address the issue. Appreciate it!

          Best,

          Komal

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.