1. FABNetv4 Connectivity Stopped Working Between Storage VM and Sites

FABNetv4 Connectivity Stopped Working Between Storage VM and Sites

Home Forums FABRIC General Questions and Discussion FABNetv4 Connectivity Stopped Working Between Storage VM and Sites

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #9309
    Arash
    Participant

      I have a Storage VM at MICH  that needs to communicate with FPGA nodes at five other sites via FABNetv4. This setup was working perfectly a couple of days ago, but now the Storage VM cannot reach any of the remote nodes (0% success rate, 100% packet loss to all sites).

      I deleted and created another storage slice and noticed an error during the creation of the slice. (image attached)

      Has there been a recent change to FABNetv4 cross-site routing policy, or is there a known outage affecting inter-site connectivity?  Any guidance on troubleshooting or recommended architecture would be greatly appreciated.

      #9311
      Tom Lehman
      Participant

        There was some maintenance last night on the underlying optical infrastructure.  I will check on status are report back here.

        Tom

        #9313
        Arash
        Participant

          Thank you, @Tom,

          I still can see that the problem exists.

           

          • This reply was modified 1 day, 1 hour ago by Arash.
          #9316
          Tom Lehman
          Participant

            The FABRIC MICH dataplane link is back in service.  FABNetv4 services are working now.

            #9317
            Arash
            Participant

              Thank you, Tom. I still have Tout from TACC to MICH and GPN to MICH. attached images.

              These notebooks were working fine a couple of days ago.

               

               

              #9320
              Arash
              Participant

                I also noticed the FabnetV4 gateways are not reachable from each of these sites as well

                “STAR”, “WASH”, “DALL”, “LOSA”, “SALT”

                #9323
                Arash
                Participant

                  It is fixed now. Thank you

                Viewing 7 posts - 1 through 7 (of 7 total)
                • You must be logged in to reply to this topic.