[Ahmad Nazar]

I made sure the config file did not have those <> characters and the fabric_rc does not have them

[Ahmad Nazar]

Hello, I ran the configure.ipynb and it was successful as I have all the files in the correct locations and the keys and the project ID, I am trying to work with the Hello FABRIC! tutorial however it is not allowing me to initialize the slice as mentioned above. Hence the attached error.

[Ahmad Nazar]

Ilya Baldin wrote:

Hello,

As @yoursunny noted please make sure you aren’t actually using the management IP address to communicate between VM slivers as that is discouraged and most of the time not possible.

It is not clear to me if you are using a jupyter notebook or building a slice from the UI (we strongly encourage new users and educators to use notebooks). Please try the ‘Local Ethernet (Layer 2): Create a private local Ethernet network on a FABRIC site (manual)’ notebook (you can find it from start_here notebook under ‘Networking’ section). If it doesn’t work please report which site you are using.

Also please make sure

• You are familiar with this article and the materials pointed out in it https://learn.fabric-testbed.net/knowledge-base/fabric-information-for-instructors/
• Educators are encouraged to post their questions on the Educator Forum rather than a general user forum.

I have tried using both. The setup I have was made using the GUI. I attempted the Jupyter Notebook multiple times however I stumble upon an error on initialization saying ”

SliceManagerException: b'{\n    "errors": [\n        {\n            "details": "error: Core API error occurred status_code: 404 message: b\'{\\\\n  \\"errors\\": [\\\\n    {\\\\n      \\"details\\": \\"No match for Project with uuid = \\\\\'<891aa44a-ef12-4c72-b45d-6017b4f00e92>\\\\\'\\",\\\\n      \\"message\\": \\"Not Found\\"\\\\n

which is strange because I have tried multiple ways of ensuring the Project ID is correct, and it can initialize in the GUI and the project for sure exists, any ideas?

[Author]

Posts